Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 540 / 564

HYDRAULIC ATTACHMENT SYSTEM Front Mount
Page 16-42 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
16
2. Remove attachment arm and interface assembly. See Attachment Arm Removal on page 16-3.
3. Relieve pressure in hydraulic system. See Relieving Hydraulic System Pressure on page 16-1.
4. Set the joystick ON/OFF switch to OFF, remove driver seat and disable vehicle.
5. Thoroughly clean the cylinders, hoses, and the area around the front mount.
6. Remove wire ties securing hoses to front mount.
7. Slowly loosen and disconnect hoses at cylinders and, if equipped, quick connect fittings. Cover hose
ends and fittings to keep out debris. See Vehicle Mounted Cylinders on page 16-26. See also Quick
Connect Fittings (Auxiliary Hydraulic Circuit only) on page 16-25.
8. Remove cylinders. See Vehicle Mounted Cylinders on page 16-26.
9. Loosen bottom of front fascia by removing two bolts securing it to vehicle (Figure 16-83, Page 16-41) .
10. Remove four bolts (1) and washers (2) from lower part of mount under front of vehicle (Figure 16-84,
Page 16-41) .
11. Remove four locknuts (3) and bolts (4) securing front of mount to vehicle (Figure 16-84, Page 16-41) .
12. Remove two nuts (5), washers (6) and bolts (7) securing top of mount to vehicle (Figure 16-84,
Page 16-41) .
13. Remove front mount, pulling at bottom of front fascia, as necessary, to clear mount.
FRONT MOUNT INSTALLATION
1. Reverse the removal procedure to install front mount to the vehicle but finger-tighten hardware until all
hardware is in place.
2. Tighten the four bolts (1) and washers (2), securing bottom of mount to chassis, to 37 ft-lb (50 N·m).
3. Tighten the four locknuts (3) and bolts (4), securing front of mount to vehicle, to 37 ft-lb (50 N·m).
4. Tighten the two nuts (5), washers (6) and bolts (7), securing top of mount to vehicle, to 37 ft-lb (50 N·m).
5. Match hoses to fittings and connect hoses (Figure 16-34, Page 16-23) . Tighten fittings to 22 ft-lb (30
N·m).