Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 372 / 564

KAWASAKI GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Engine Control Linkages
Page 13a-20 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13A
5. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
CHOKE CABLE
Choke Cable Removal
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL and chock the rear wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Remove seat(s).
4. Remove the center seat plate (bucket seat vehicles only).
5. Remove the engine top cover.
6. Remove the choke cable return spring (1) from the hook on the choke lever (Figure 13a-18,
Page 13a-21) .
7. Remove the Z-shaped cable end (2) from the choke lever on the carburetor.
8. Remove the engine front cover (4) (Figure 13a-19, Page 13a-21) .
9. Remove the cable sheath strain relief (3) from the engine front cover (Figure 13a-19, Page 13a-21) .
10. Raise the hood.
11. Compress the choke ferrule tines on the back side of the instrument panel. Pull the cable up from the
engine compartment and remove the cable. See following NOTE.
Figure 13a-17 Z-Shaped Cable End in Hole at Pedal
Cable End
Hole in
Pedal