Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 542 / 564

HYDRAULIC ATTACHMENT SYSTEM Hydraulic Pump Assembly
Page 16-44 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
16
13. Operate pump again using the joystick and auxiliary hydraulic switch to push old fluid out of the hoses.
14. Reconnect hoses and refill reservoir.
15. Prime the pump. See Priming the Pump, Section 16, Page 16-49.
If foreign fluid is present within power unit that must be drained before operation
Follow steps above except for the following:
1. For step 5, also slowly loosen and disconnect hoses at pump.
2. For step 9, purge hoses of fluid with compressed air.
PUMP ASSEMBLY
ý
WARNING
• Wear safety glasses to prevent eye injury when any of the following conditions exist:
- Fluids are under pressure.
- Flying debris or loose material is present.
- Engine is running.
- Tools are being used.
CAUT ION
• When repairing hydraulic systems, clean the work area before disassembly and keep all parts
clean. Always use caps and plugs on hoses, tubelines and ports to keep dirt out. Dirt can
quickly damage the system.
NOTE: Mark hoses for correct installation if factory markings are not found.
Contain and dispose of any leaking oil in an environmentally safe manner.
Pump Assembly Removal
1. Empty and remove cargo bed. See Cargo Bed Removal, Section 4, Page 4-12.
2. Relieve pressure. See Relieving Hydraulic System Pressure on page 16-1.
3. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
4. Set the joystick ON/OFF switch to OFF and remove driver seat.
5. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
6. Release the clamp securing the vent hose to top of clutch cover and remove hose.
7. Thoroughly clean the filler cap, reservoir, pump assembly, hose connections and the area around the
pump assembly.
8. Loosen two bolts, located under pump assembly, securing pump assembly to cradle (Figure 16-90,
Page 16-46) .