Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 370 / 564

KAWASAKI GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Engine Control Linkages
Page 13a-18 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13A
ENGINE CONTROL LINKAGES
ACCELERATOR CABLE
See General Warning, Section 1, Page 1-1.
ý
WARNING
• To avoid unintentionally starting the vehicle:
- Disconnect battery cables, negative (–) cable first (Figure 1-2, Page 1-3).
- Disconnect the spark plug wires from the spark plugs.
Accelerator Cable Removal
NOTE: When the accelerator cable is replaced, the high-speed RPM must be adjusted. See High-Speed
RPM Adjustment on page 13a-22.
1. Turn the key switch OFF and place the Forward/Reverse handle in NEUTRAL. Remove the key. Chock
the rear wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Raise the hood.
4. Remove the seat(s) and the engine top cover. See Seat Removal, Section 4, Page 4-9.
5. Disconnect the accelerator cable (3) from the engine (Figure 13a-16, Page 13a-19) .
5.1. Remove the E-clip (6) securing the cable ring end (7) and remove the accelerator cable (3) from the
accelerator linkage pin (8)
5.2. Remove the cable sheath strain relief (4) from the bracket (5).
6. Release the retention clip (2) at the pedal bracket (Figure 13a-15, Page 13a-18) .
7. Disconnect the Z-shaped end (1) on the accelerator cable from the pedal (Figure 13a-14, Page 13a-18).
Figure 13a-14 Z-Shaped Cable End
(Gasoline Vehicles)
Figure 13a-15 Accelerator Cable Pedal Bracket
(Gasoline Vehicles)
1
2