Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 479 / 564

DRIVETRAIN COMPONENTS Rear Driveshaft
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 14-11
14
9. Install both rear brake calipers to axle. See Rear Brake Caliper Installation, Section 6, Page 6-9.
10. Secure the hydraulic brake lines to the rubber grommets at all frame locations. See following CAUTION.
ý
CAUTION
• Do not kink, twist, or damage the hydraulic brake lines.
11. Secure the P-clamp to the hydraulic brake line on top of the differential body. Tighten the hardware to 132
in-lb (15 N·m) (Figure 14-14, Page 14-9) .
12. Secure the hydraulic line T-fitting to the receiver hitch frame and tighten the bolt to 48 in-lb (7 N·m)
(Figure 14-13, Page 14-9) .
13. Adjust the park brake. See Park Brake Adjustment, Section 6, Page 6-25.
14. Install both rear wheels and finger-tighten the lug nuts.
15. Lift the rear of the vehicle with a chain hoist or floor jack and remove jack stands. See WARNING “Lift
only one end...” in General Warning, Section 1, Page 1-2.
16. Lower and remove the floor jack.
17. Use a crisscross pattern to tighten the lug nuts on both rear wheels to 85 ft-lb (115 N·m).
18. Gasoline vehicles: Connect the spark plug wires.
19. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
REAR DRIVESHAFT
REAR DRIVESHAFT REMOVAL
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL.
2. Push the car to a position that enables easy access to the roll pin securing the rear driveshaft to the dif-
ferential pinion shaft (Figure 14-8, Page 14-5) . Chock the front wheels.
Figure 14-17 Lower Driver Side Shock Mount