Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 226 / 564

TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES Test Procedures
Page 11b-30 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
11B
TEST PROCEDURE 19 – REVERSE WARNING BUZZER LIMIT SWITCH
See General Warning, Section 1, Page 1-1.
NOTE: Keep the battery connected during this test procedure.
The reverse warning buzzer limit switch is located on the Forward/Reverse handle under the hood.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Check for proper wiring and tight connections at the reverse warning buzzer and the reverse warning
buzzer limit switch (Figure 11b-25, Page 11b-30) .
3. Move the Forward/Reverse handle to REVERSE and listen for an audible click from the limit switch. If
there is no click, check the switch for proper alignment and switch arm movement.
4. If the switch is being activated but the buzzer does not function, place the red (+) probe of the multimeter
on one terminal and the black (–) probe on the other terminal of the limit switch. With the lever fully
released, the reading should be no continuity.
5. Place the Forward/Reverse handle in the REVERSE position to activate the limit switch. The multimeter
should indicate continuity when the limit switch lever is activated. If either reading is incorrect, replace
the limit switch
(Figure 11b-25, Page 11b-30) .
TEST PROCEDURE 20 – REVERSE WARNING BUZZER
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery as instructed. See WARNING “To avoid unintentionally starting...” in General
Warning, Section 1, Page 1-1.
3. Check for proper wiring and tight connections. Use a multimeter and check for continuity through each
wire that connects to the reverse warning buzzer individually. See Wiring Diagram, Section 11b,
Page 11b-6. If the buzzer does not function when properly wired, replace the buzzer. See Reverse
Warning Buzzer Removal, Section 12b, Page 12b-10.
Figure 11b-25 Reverse Warning Buzzer and Limit
Switch