Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 518 / 564

HYDRAULIC ATTACHMENT SYSTEM Electrical
Page 16-20 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
16
Solenoid Installation
1. Attach solenoid to motor with screws.
2. Connect wires and copper strap to solenoid. Tighten hardware on the small terminals to 10 in-lb (1.1
N·m) and 21 in-lb (2.4 N·m) on the large terminals.
3. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
4. Lower the cargo bed.
CIRCUIT BREAKER
Testing the Circuit Breaker
1. Check for continuity between each post.
2. If there is no continuity, press the reset button and check again for continuity.
3. If there is still no continuity, replace the breaker.
Circuit Breaker Removal
1. Empty and raise cargo bed.
2. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
3. Set the joystick ON/OFF switch to OFF.
4. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
5. Disconnect wires from each post of circuit breaker.
6. Remove hardware securing breaker to chassis and remove breaker.
Circuit Breaker Installation
1. Attach breaker to chassis with screws and tighten to 75 in-lb (8.5 N·m).
2. Connect wires to breaker. Tighten nuts to 75 in-lb (8.5 N·m).
3. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
4. Lower the cargo bed.