Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 401 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Fuel System
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 13b-11
13B
Ensure the replacement gasket is rubber and that the mounting holes in the gasket are aligned
properly with the mounting holes on the fuel tank.
2. Feed a new sending unit rheostat arm and float (4) into the fuel tank (Figure 13b-4, Page 13b-10) . The
rheostat arm and float should be positioned toward the outside surface of the fuel tank (Figure 13b-6,
Page 13b-11) .
3. Align the flange identification mounting holes (1) directly over the corresponding mounting holes in the
gasket and fuel tank (Figure 13b-5, Page 13b-11) . See following CAUTION and NOTE.
ý
CAUTION
• Ensure all mounting holes in the fuel level sending unit, gasket, and fuel tank are aligned
properly before hardware is installed. Improper alignment of the mounting holes could result
in an incomplete seal between the fuel level sending unit and the fuel tank.
NOTE: The fuel level sending unit mounts to the fuel tank only one way. If the unit does not fit on the fuel
tank correctly, adjust the unit until it is properly aligned with the fuel tank.
4. Carefully thread each hex-head screw by hand, with the ring terminal on the black ground wire (6) under
the screw head closest to the engine (Figure 13b-4, Page 13b-10) . See following CAUTION.
CAUT ION
• Use only the existing screws or new plastic-thread screws made for plastics applications. Do
not use sheet metal screws as replacement hardware.
Figure 13b-5 Fuel Level Sending Unit Alignment Figure 13b-6 Fuel Level Sending Unit Position
1
2
3
5
4
4
11
Tank viewed from front of vehicle.