Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 221 / 564

TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES Test Procedures
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 11b-25
11B
5. Check for continuity on the switch contacts with the Forward/Reverse handle in the NEUTRAL position
(Figure 11b-19, Page 11b-24) . The multimeter should indicate continuity.
6. Check for continuity on the switch contacts with the Forward/Reverse handle in the REVERSE position
(Figure 11b-20, Page 11b-25) . The multimeter should indicate no continuity.
7. If any of the continuity readings are incorrect, replace the neutral switch. See Neutral Switch Removal
on page 12b-2.
TEST PROCEDURE 11 – WIRE CONTINUITY
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. To test a wire for continuity, disconnect either end from the electrical component to which it is attached.
4. Set the multimeter to 200 ohms and place the red (+) probe on the terminal at one end of the wire. Place
the black (–) probe on the other terminal end of the wire. The reading should indicate continuity. If the
reading is incorrect, repair or replace the wire.
See following NOTE.
NOTE: When checking continuity of wires in the wire harness, observe the polarity of diodes. Testing con-
tinuity of certain wires will require the appropriate diode test procedure.
See Test Procedure 9 –
Wire Harness Diodes on page 11b-18.
TEST PROCEDURE 12 – FRONT DRIVE GEARCASE COIL
See General Warning, Section 1, Page 1-1.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery as instructed. See WARNING “To avoid unintentionally starting...” in General
Warning, Section 1, Page 1-1.
Figure 11b-20 Neutral Switch – Reverse Position