Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 454 / 564

DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Air Intake System
Page 13c-24 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13C
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Remove the air filter cartridge. See Air Filter Removal on page 13c-23.
4. Remove the bottom (inlet) hose from the canister (Figure 13c-28, Page 13c-26) .
5. Remove the top (outlet) hose from the canister.
6. Remove the two bolts and park brake cable from the canister and remove the canister.
AIR CANISTER INSTALLATION
1. Position the canister next to the frame bracket with the tab lock released and oriented toward the pas-
senger side.
2. Install two bolts on the canister base bracket and vehicle frame bracket. Tighten the bolts to 21 ft-lb (28.5
N·m).
3. Secure the bottom (inlet) hose to the canister port.
4. Secure the top (outlet) hose to the canister port.
5. Install a new air filter cartridge. See Air Filter Installation on page 13c-23.
6. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
AIR FILTER INTAKE HOSE REMOVAL
The air filter intake hose fits between the driver-side frame and the inlet port on the air filter canister. The
frame serves as a duct to draw air from a location at the top of the front of the vehicle.
See following CAU-
TION.
ý
CAUTION
• Do not drill holes or attach anything to the driver side of the frame. A penetrating fastener will
create passages that could allow moisture and/or dirt to enter the engine air intake system.
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL.
Figure 13c-25 Air Filter Canister