Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 415 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Choke and Air Intake System
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 13b-25
13B
Air Filter Removal
1. Release both canister tab locks (Figure 13b-24, Page 13b-25) .
2. Pull the canister cap away from the canister.
3. Remove the air filter cartridge. See following NOTE.
NOTE: The filter cartridge is specifically designed for this engine. It fits into the canister only one way. Use
only direct replacement part (CCI P/N 102498601).
Air Filter Installation
1. Push the new filter cartridge onto the nozzle inside the canister.
2. Position the canister cap so the TOP mark is at the top center of the canister (Figure 13b-24,
Page 13b-25) .
3. Use both tab locks on the sides of the cap to secure the canister cap.
CHOKE CABLE REMOVAL
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL and chock the rear wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Remove both seats.
4. Remove the center seat plate.
5. Remove the engine cover plate.
6. Remove the cable sheath strain relief from the engine bracket (Figure 13b-25, Page 13b-26) .
7. Remove the Z-shaped cable end from the choke control on the carburetor.
8. Raise the hood.
9. Compress the choke ferrule tines on the back side of the instrument panel. Pull the cable up from the
engine compartment and remove the cable. See following NOTE.
Figure 13b-24 Air Filter Cartridge