Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 413 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Engine Control Linkages
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 13b-23
13B
ENGINE GOVERNOR ARM
Engine Governor Arm Removal
1. Remove the governor guard. See Governor Guard Removal on page 13b-19.
2. Disconnect the intake hose from the engine.
3. Disconnect the governor wire spring (11) from the engine governor arm (6) (Figure 13b-21,
Page 13b-22) .
4. Disengage the governor wire (12) from the carburetor and remove it from the engine governor arm (6).
5. Disengage the idle spring (13) from the engine governor arm (6) and idle adjuster (14).
6. Loosen the pinch nut (15) until the governor arm (6) can be removed from the slotted pin (16).
Engine Governor Arm Installation
1. Slide the engine governor arm (6) onto the slotted pin (16) (Figure 13b-21, Page 13b-22) .
2. Insert the straight end of the governor wire (12) through the top hole in the engine governor arm as shown
(Figure 13b-21, Page 13b-22) .
3. Insert the bent end of the engine governor wire (12) into the carburetor throttle. Secure the wire with a
clip.
4. Insert the governor wire spring (11) into the bottom hole in the engine governor arm as shown
(Figure 13b-21, Page 13b-22) .
5. Ensure the governor cable is inserted into the loop in the governor wire (9). Insert the idle spring (13) into
the engine governor arm (6) and stretch it to insert it into the idle adjuster (14).
6. Ensure the engine governor arm is in the wide-open throttle position and that it is securely positioned on
the slotted pin (16).
7. Ensure the engine governor arm is in the wide-open throttle position. Use a flat-blade screwdriver to
rotate the slotted pin (16) counterclockwise until it stops and hold it into position. Hold the screwdriver in
place and use a 7/16-inch socket to tighten the pinch nut (15) to 35 in-lb (4 N·m).
8. Connect the intake hose to the engine.
9. Check the engine idle speed. See Idle RPM Adjustment on page 13b-23.
10. Install the governor guard. See Governor Guard Installation on page 13b-19.
ENGINE RPM ADJUSTMENT
Idle RPM Adjustment
ý
DANGER
• Do not operate the engine in an enclosed area without proper ventilation. The engine
produces carbon monoxide, which is an odorless, deadly poison.
1. Turn the key switch to start and run the engine. Place the Forward/Reverse handle in NEUTRAL. Place
a tachometer (CCI P/N 1016112) close to the spark plug wire and plug.
2. Hold the throttle against the stop screw and adjust the idle-adjustment screw on the carburetor until the
tachometer displays 1125 ± 25 RPM. See following NOTE.
NOTE: Turn the screw counterclockwise to raise the RPM and clockwise to lower the RPM.
3. Release the throttle.