Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 318 / 564

ELECTRICAL COMPONENTS: HONDA POWERED GASOLINE VEHICLES Bed Lift Switch
Page 12b-8 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
12B
BED LIFT SWITCH
Testing the Bed Lift Switch
See Test Procedure 30, Section 11b, Page 11b-39.
Bed Lift Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Raise the hood.
4. Press the upper and lower retaining tabs and push the bed lift switch (9) out of the instrument panel
(Figure 12b-5, Page 12b-5) .
5. Disconnect the wire harness from the bed lift switch.
Bed Lift Switch Installation
1. Match the terminal numbers molded onto the connector and switch and reconnect the wire harness.
2. Push the bed lift switch into the instrument panel until fully seated.
3. Lower and secure the hood.
4. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
BED LIFT CIRCUIT BREAKER
Testing the Bed Lift Circuit Breaker
See Test Procedure 31, Section 11b, Page 11b-40.
Bed Lift Circuit Breaker Removal
1. Push the bed lift switch (9) out of the instrument panel. See Bed Lift Switch Removal on page 12b-8.
2. Locate the bed lift circuit breaker (10) on the orange wire of the wire harness connected to the switch
(Figure 12b-5, Page 12b-5) .
3. Pull the circuit breaker out of the in-line fuse holder to remove.
Bed Lift Circuit Breaker Installation
Install the circuit breaker in the reverse order of removal.