REAR SUSPENSION
Swing Arms
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
Page 9-3
9
5. Remove the urethane bushings and teflon impregnated steel sleeves from the swing arms.
6. Remove the urethane bushings from the swing arm brackets on the frame.
SWING ARM INSTALLATION
1. Replace the urethane bushings in the swing arm brackets on the frame.
2. Install new teflon impregnated steel sleeves into new swing arm urethane bushings.
3. Install the urethane bushings and teflon impregnated sleeves (as an assembly) into the swing arms.
NOTE:
The urethane bushings fit tight. Use a heavy soap compound, light grease, or STP oil treatment on
the outside surface of the urethane bushings to reduce friction during installation.
4. Position the swing arm between the frame brackets and bracket bushings with the axle pad face down.
Slide the swing arm pivot bolt into place with the grease pin to the inside of the vehicle frame
(Figure 9-4,
Page 9-3)
.
See following NOTE and CAUTION
.
NOTE:
It may be necessary to tap the bolt into place. If so, remove the grease fitting before tapping or
hammering the bolt end.
CAUT ION
• Do not hammer or drive against the grease fitting.
5. Install the washer and locknut on the pivot bolt and tighten to 14 ft-lb (18 N·m)
(Figure 9-3, Page 9-3)
.
6. Attach a new rue pin to the pivot bolt.
7. Install the rear axle.
See Rear Axle Installation, Section 14, Page 14-10.
Figure 9-3 Swing Arm Bolt, Nut and Rue Pin
Figure 9-4 Swing Arm Bolt Grease Fitting
Содержание IntelliTach XRT 1550
