Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 476 / 564

DRIVETRAIN COMPONENTS Rear Axle
Page 14-8 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
14
4. Secure the hydraulic brake line in the rubber grommets on the hitch frame.
5. Connect the battery cables, positive (+) cable first, and tighten the hardware to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
REAR AXLE
REAR AXLE REMOVAL
1. Unload the cargo bed. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle
in NEUTRAL. Chock the front wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Gasoline vehicles: Disconnect the spark plug wires. See WARNING “To avoid unintentionally start-
ing...” in General Warning, Section 1, Page 1-2.
4. Loosen the lug nuts on the rear wheels and lift the rear of the vehicle with a chain hoist or floor jack. See
WARNING “Lift only one end...” in General Warning, Section 1, Page 1-2.
5. Place jack stands under the outside frames, as close to the rear of the vehicle as the frames will support.
Lower the vehicle onto the stands (Figure 14-12, Page 14-8) . See following DANGER.
ý
DANGER
• Ensure that the weight of the vehicle is positioned to the front of the vehicle and the jack
stands are as far back on the vehicle frame tubes as possible.
6. Remove both rear wheels.
7. Remove the hydraulic brake line T-fitting and bracket from the passenger-side receiver frame
(Figure 14-13, Page 14-9) .
8. Remove the hydraulic brake line P-clamp from the rear differential (Figure 14-14, Page 14-9) .
Figure 14-12 Jack Stands Under Rear of Frame