Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 414 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Choke and Air Intake System
Page 13b-24 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13B
4. Adjust the idle-adjustment screw above the No. 2 cylinder exhaust port until the tachometer displays
1300 ± 50 RPM. See previous NOTE.
High-Speed RPM Adjustment
ý
DANGER
• Do not operate the engine in an enclosed area without proper ventilation. The engine
produces carbon monoxide, which is an odorless, deadly poison.
1. Press the accelerator pedal all the way to the floor.
2. Place a tachometer (CCI P/N 1016112) close to the spark pug wire and plug.
3. Adjust the high-speed adjustment screw (1) until the tachometer displays 3825 ± 25 RPM
(Figure 13b-23, Page 13b-24) . See following NOTE.
NOTE: Turn the screw counterclockwise to raise the RPM and clockwise to lower the RPM.
4. Release the accelerator pedal.
CHOKE AND AIR INTAKE SYSTEM
See General Warning, Section 1, Page 1-1.
AIR FILTER REPLACEMENT
The air filter should be inspected periodically and replaced when necessary. Filter changes should not exceed
the recommended interval.
See Periodic Service Schedule, Section 10a, Page 10a-1. More frequent ser-
vice may be required in extremely dirty operating environments. In the event of a loss of power, sluggish
acceleration, or a roughly running engine with excessive black exhaust, service the air filter immediately.
CAUT ION
• Do not drill into the driver-side frame. Failure to heed this caution could damage the engine by
allowing excessive contamination to enter the air intake system.
Figure 13b-23 High-speed Adjustment Screw
1