Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 339 / 564

ELECTRICAL COMPONENTS: DIESEL VEHICLES Reverse Warning Buzzer Limit Switch (If Equipped)
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 12c-11
12C
Reverse Warning Buzzer Installation
1. Install the reverse warning buzzer and secure it with two plastic rivets.
2. Connect the black wire from the wire harness to the negative (–) terminal on the buzzer.
3. Connect the red/white wire from the wire harness to the positive (+) terminal on the buzzer.
4. Lower and secure the hood.
5. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
REVERSE WARNING BUZZER LIMIT SWITCH (IF EQUIPPED)
See General Warning, Section 1, Page 1-1.
Testing the Reverse Warning Buzzer Limit Switch
See Test Procedure 22, Section 11c, Page 11c-41.
Reverse Warning Buzzer Limit Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Raise the hood.
4. Disconnect the wires from the reverse warning buzzer limit switch (Figure 12c-7, Page 12c-11) .
5. Remove the screws, nuts, washers, and lockwashers that secure the limit switch.
6. Remove the limit switch.
Figure 12c-7 Reverse Warning Buzzer and Limit
Switch