Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 48 / 564

BODY AND TRIM Safety Belts
Page 4-10 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
4
ING.
3. Bench seat
3.1. Hold center seatbelt buckles up and out of the way. Lower rear of seat to frame.
SEAT SUPPORT REMOVAL
1. Remove the bolts (9), washers (10 and 11), and flanged locknuts (12) from the seat support (7) and
engine cover plate (Figure 4-1, Page 4-7) .
2. Remove the seat support.
SEAT SUPPORT INSTALLATION
1. Install the seat support (7) (Figure 4-1, Page 4-7) .
2. Secure the seat support to the seat side plates with bolts (9), washers (10 and 11), and flanged locknuts
(12). Tighten the hardware to 37 ft-lb (50 N·m).
SAFETY BELTS
See General Warning, Section 1, Page 1-1.
ý
CAUT ION
• Be careful not to damage the safety belt webbing or hardware.
• Inspect the safety belt system periodically. Check for cuts, fraying, and loose parts. Replace
damaged parts immediately. Do not disassemble or modify the system.
• Keep safety belts clean and dry. If cleaning is necessary, use a solution of mild soap and
lukewarm water. Do not use bleach, dye, or abrasive cleaners as they may severely weaken
the safety belts.
• Do not insert coins, clips, etc. into the safety belt buckle. Foreign objects may interfere with
the buckle locking mechanism.
• If the safety belt does not function normally, contact your dealer/distributor or trained
technician immediately. Do not occupy the seat until the safety belt is repaired.
SAFETY BELT REMOVAL
1. Remove the bolt from the base of the coiled safety belt assembly (outside location) (Figure 4-2,
Page 4-11) .
2. Remove the coiled safety belt assembly.
3. Remove the bolt from the safety belt buckle assembly (center location) (Figure 4-3, Page 4-11) .