Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 116 / 564

REAR SUSPENSION Swing Arms
Page 9-2 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
9
Rear Shock Absorber Removal, Continued:
Rear Shock Absorber Installation
Ensure that the adjustment position of the coil spring on the new shock absorber is the same as the previous
shock absorber. Use the adjustment position on the coil spring from the previous shock absorbers as a refer-
ence.
See following NOTE.
NOTE: When shock absorbers are installed, ensure both shock absorbers have identical part numbers.
1. Install the top bolt, flat washer, and a new locknut. Tighten the hardware to 73 ft-lb (99 N·m).
2. Secure the bottom of the shock mount to the driver side axle frame bracket with a bolt, flat washer, rubber
grommet bracket, and a new locknut. Tighten the hardware to 73 ft-lb (99 N·m).
3. Install the hydraulic line rubber grommet in the shock bracket.
4. Install the rear tire and wheel. Finger-tighten the lug nuts.
5. Repeat steps 1 through 4 for the remaining rear coil spring and shock.
6. Raise the vehicle, and remove the jack stands.
7. Lower the floor jack from the hitch frame.
8. Tighten the lug nuts on both wheels to 85 ft-lb (115 N·m).
SWING ARMS
See General Warning, Section 1, Page 1-1.
SWING ARM REMOVAL
1. Remove the rear axle. See Rear Axle Removal, Section 14, Page 14-8.
2. Remove the rue pin, locknut and washer from the swing arm pivot bolt (Figure 9-3, Page 9-3) .
3. Remove the swing arm bolt and grease fitting (Figure 9-4, Page 9-3) . See following NOTE.
NOTE: Do not hammer against the threaded end of the swing arm bolt.
4. Remove the swing arm.
Figure 9-1 Locate Rear Jack Stands Figure 9-2 Remove Lower Driver-Side Shock Bolt