Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 321 / 564

ELECTRICAL COMPONENTS: HONDA POWERED GASOLINE VEHICLES Reverse Warning Buzzer Limit Switch
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 12b-11
12B
REVERSE WARNING BUZZER LIMIT SWITCH
See General Warning, Section 1, Page 1-1.
Testing the Reverse Warning Buzzer Limit Switch
See Test Procedure 19, Section 11b, Page 11b-30.
Reverse Warning Buzzer Limit Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Raise the hood.
4. Disconnect the wires from the reverse warning buzzer limit switch (Figure 12b-6, Page 12b-10) .
5. Remove the screws, nuts, washers, and lockwashers that secure the limit switch.
6. Remove the limit switch.
Reverse Warning Buzzer Limit Switch Installation
1. Install the reverse warning buzzer limit switch in the reverse order of removal.
2. Place the Forward/Reverse handle in the REVERSE position.
3. Tighten the limit switch mounting screws so that they are snug, but the limit switch can still be rotated in
the adjustment slot (Figure 12b-7, Page 12b-11) .
4. Rotate the limit switch so that the lobe on the Forward/Reverse handle activates the limit switch as shown
(Figure 12b-8, Page 12b-11) .
5. Hold the limit switch in position and tighten the mounting screws and nuts to 4 in-lb (0.5 N·m). See fol-
lowing CAUTION.
Figure 12b-7 Reverse Warning Buzzer Limit Switch
Adjustment Slot
Figure 12b-8 Reverse Warning Buzzer Limit Switch
(Properly Adjusted)