Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 399 / 564

HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Fuel System
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 13b-9
13B
Jet Elevation/Size Chart. After the proper jet size is determined, replace the main jet. See the Honda
GX620 engine manual (CCI P/N 102615401).
The following chart lists the elevation ratings for various jet sizes. No adjustment is required for the pilot jet. If
the vehicle idles roughly, adjust the pilot air screw until the vehicle idles smoothly.
Main Jet Elevation/Size Chart
FUEL LEVEL SENDING UNIT
See General Warning, Section 1, Page 1-1.
Fuel Level Sending Unit Removal
ý
DANGER
• Gasoline! Flammable! Explosive! Do not smoke. Keep sparks and flames away from the
vehicle and service area.
ý
WARNING
• Do not use electrically powered tools to remove or install the fuel level sending unit. Failure to
heed this warning could result in a fire or explosion.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Disconnect the spark plug wires. See WARNING “To avoid unintentionally starting...” in General
Warning, Section 1, Page 1-1.
4. Remove the passenger seat. See Seat Removal, Section 4, Page 4-9.
5. Remove the rubber boot (8) from the center post on the fuel level sending unit. Remove the nut (9) from
the center post and remove the orange wire (7) (Figure 13b-4, Page 13b-10) . Retain the hardware.
6. Remove the hex-head plastic thread screw (10) securing the black ground wire (6) to the fuel level send-
ing unit and remove the black ground wire. Retain the hardware.
7. Remove the four remaining hex-head plastic thread screws from the fuel level sending unit flange (5).
Retain the hardware.
8. Carefully remove the sending unit and gasket (3). Feed the rheostat arm and float (4) through the fuel
tank hole. Immediately place the fuel level sending unit in a pan to catch fuel. See following DANGER
and NOTE.
ALTITUDE
HONDA GX620
ENGINE
MAIN JET SIZE
0-5000 ft.
(0-1524 m)
108
5000-8000 ft.
(1524-2438 m)
105
8000 ft. and higher
(2438 m and higher)
102