Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 478 / 564

DRIVETRAIN COMPONENTS Rear Axle
Page 14-10 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
14
18. Support the rear driveshaft and slide the rear axle out of the driveshaft universal joint and away from the
swing arm brackets. See preceding NOTE.
19. Move the rear axle to a safe area away from the vehicle. See previous NOTE.
REAR AXLE INSTALLATION
NOTE: These procedures are best performed with the help of an assistant.
1. Support the differential with a floor jack and place the rear axle under the vehicle, just below the swing
arms.
2. Support the longest end of the axle assembly and raise the axle up to the swing arm axle mounting
plates.
3. With roll pin holes aligned, slide the differential pinion shaft into the driveshaft universal joint.
4. Center roll pin holes and drive a new roll pin into place. See following NOTE.
NOTE: The roll pin should be slightly below the surface on both sides of the coupling.
Use a 1/4-inch roll pin punch to drive the roll pin into place.
5. Secure the axle to the outside of the swing arms at four locations with new bolts and washers. If new bolts
are not available, clean existing bolts and add Loctite 2760 per instructions. Finger-tighten the hardware.
6. Secure the rear receiver hitch to the inside of the swing arms and axle at four locations with new bolts
and washers. If new bolts are not available, clean existing bolts and add Loctite 2760 per instructions.
Finger-tighten the hardware.
7. Tighten all eight axle mounting bolts to 95 ft-lb (129 N·m).
8. Secure shock absorbers to axle (Figure 14-17, Page 14-11) . See following NOTE.
NOTE: Hydraulic brake line brackets fit to the right side of both lower shock mounts.
Figure 14-15 Park Brake Cable and Hex-Head Bolts Figure 14-16 Position Floor Jack Under Differential