HONDA GASOLINE ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES
Fuel System
Page 13b-8
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13B
FUEL LINES
See General Warning, Section 1, Page 1-1.
The fuel lines must be properly routed and all hose clamps must be tight
(Figure 13b-3, Page 13b-7)
. The
fuel lines should be kept clean.
See following NOTE and WARNING.
NOTE:
Use only 1/4-inch hoses with SAE J30R7 rating to replace the fuel lines.
ý
WARNING
• Make sure fuel lines are the correct length and are properly routed. Failure to heed this
warning could result in damage to the fuel lines and fire.
FUEL FILTER
See General Warning, Section 1, Page 1-1.
One in-line filter (3) is installed between the fuel tank and the fuel pump
(Figure 13b-3, Page 13b-7)
. Fuel fil-
ters, fuel lines, and the fuel tank vent should be inspected periodically for leaks and replaced when necessary.
Filter changes should not exceed the recommended interval.
See Periodic Service Schedule on
page 10a-1.
Replace the fuel filter as instructed.
See the Honda GX620 engine manual (CCI P/N
102615401).
FUEL PUMP
See General Warning, Section 1, Page 1-1.
Procedures for inspection, removal, and installation can be found in the engine manual.
See the Honda
GX620 engine manual (CCI P/N 102615401).
CARBURETOR
See General Warning, Section 1, Page 1-1.
Before suspecting the carburetor as the cause of poor engine performance, make sure the fuel and ignition
systems are in proper operating condition. Check the following items:
•
Spark plug and gap condition.
See the Honda GX620 engine manual (CCI P/N 102615401).
•
Air filter element.
See Air Filter Replacement on page 13b-24.
•
Fuel filters.
See Fuel Filter on page 13b-8.
•
Choke and air intake system (for restriction of air flow).
See Choke and Air Intake System on
page 13b-24.
•
Fuel pump.
See the Honda GX620 engine manual (CCI P/N 102615401).
•
Fuel lines (from fuel tank to filter to pump to carburetor).
See Fuel Lines on page 13b-8.
•
Exhaust system (for restrictions).
If the carburetor has failed, replace it.
See the Honda GX620 engine manual (CCI P/N 102615401).
Carburetor Jetting
The Honda GX620 engine is equipped with a carburetor that has fixed jets. These fixed jets do not require
adjustment. The size of the main jet is determined by the altitude where the engine will be operating. The main
jet size is set for the operating elevation of customer destination at the time of manufacture. In the event that
carburetor jetting needs to be changed, determine the proper jet size for the operating altitude.
See the Main
Содержание IntelliTach XRT 1550
