Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 341 / 564

ELECTRICAL COMPONENTS: DIESEL VEHICLES Front Differential Limit Switch
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 12c-13
12C
FRONT DIFFERENTIAL LIMIT SWITCH
See General Warning, Section 1, Page 1-1.
Testing the Front Differential Limit Switch
See Test Procedure 16, Section 11c, Page 11c-36.
Front Differential Limit Switch Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Raise the hood.
4. Disconnect the black and red wire leads of the switch (1) from the gray wires of the wire harness
(Figure 12c-10, Page 12c-13) .
5. Remove the nuts (2) and screws (3) that secure the switch (1) and remove the switch.
Front Differential Limit Switch Installation
1. Install the front differential limit switch (1) in the reverse order of removal and tighten the nuts (2) to 4 in-
lb (0.5 N·m) (Figure 12c-10, Page 12c-13) . See following CAUTION.
CAUT ION
• Do not overtighten the retaining nuts. If the nuts are overtightened, the switch could become
damaged.
2. Move the accelerator pedal back and forth to ensure that the switch lever is being properly activated.
3. Connect the black and red wire leads of the switch to the gray wires of the wire harness.
4. Lower and secure the hood.
5. Connect the battery cables, positive (+) cable first, and tighten the terminals to 144 in-lb (16 N·m). Coat
terminals with Battery Terminal Protector Spray (CCI P/N 1014305).
Figure 12c-10 Front Differential Limit Switch Removal
1
3
2