Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 86 / 564

HYDRAULIC AND PARK BRAKE SYSTEMS Park Brake System
Page 6-26 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
6
PARK BRAKE WHEEL CABLES
Right Rear Cable Removal
1. Chock the rear wheels and release the park brake.
2. Remove the hex-head bolt and P-clamp securing the cable to the air cleaner mounting bracket.
3. Cut the nylon wire tie securing the cable to the frame.
4. Remove the C-clip from the right rear cable sheath adjacent to the caliper.
5. Slide the cable forward to release the sheath ferrule from the caliper bracket.
6. Move the cable up and toward the rear of the vehicle and remove the cable from the caliper arm
(Figure 6-21, Page 6-26) .
7. Disconnect the threaded end of the cable from the frame bracket and remove the cable (Figure 6-22,
Page 6-26) .
Left Rear Cable Removal
1. Chock the rear wheels and release the park brake.
2. Remove the P-clamp and nylon wire tie securing the cable to the frame.
3. Remove the C-clip from the right rear cable sheath adjacent to the caliper.
4. Slide the cable forward to release the sheath ferrule from the caliper bracket.
5. Move the cable up and toward the rear of the vehicle to remove the cable end from the caliper arm
(Figure 6-21, Page 6-26)
6. Squeeze the ferrule tines together on the cable end at the frame bracket and remove the cable from the
vehicle (Figure 6-22, Page 6-26) .
Right Rear Cable Installation
1. Install the caliper end of the cable into the brake caliper arm (Figure 6-21, Page 6-26) .
2. Slide the sheath ferrule through the hole in the caliper mounting bracket.
3. Install a C-clip to hold the cable ferrule in place.
4. Route the cable up and across the air filter box and secure the P-clamp and cable to the top bolt on the
filter mounting bracket (Figure 6-23, Page 6-27) .
Figure 6-21 Park Brake Cable Attachment Figure 6-22 Park Brake Frame Bracket