Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 49 / 564

BODY AND TRIM Cargo Bed – Electric Lift
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 4-11
4
4. Remove the safety belt buckle assembly.
SAFETY BELT INSTALLATION
1. Install the center safety belt buckle assembly to the seat belt bracket with a new thread-forming bolt. Ori-
ent the assembly with the buckle end pointed up slightly, and tighten the hardware to 55 ft-lb (75 N·m).
2. Install the coiled safety belt assembly on the outside of the ROPS seat support with a new thread-forming
bolt. Orient the assembly with the tang end pointed up slightly, and tighten the hardware to 55 ft-lb
(75 N·m).
CARGO BED – ELECTRIC LIFT
See General Warning, Section 1, Page 1-1.
TESTING THE BED LIFT MOTOR
Gasoline Vehicles: See Test Procedure 29, Section 11a, Page 11a-39.
Diesel Vehicles: See Test Procedure 34, Section 11c, Page 11c-51.
BED LIFT MOTOR REMOVAL
1. Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove
the key. Chock the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. With the bed in the down position, working from under the vehicle, disconnect the two wires from the con-
nectors at the electric bed lift motor.
4. Remove the locknut, bolt, sleeve, spacers and washers from the rod end of the bed lift motor and bed
frame.
5. Remove the locknut, bolt, sleeve, spacers and washers from the base of the bed lift motor and vehicle
frame and remove the bed lift motor.
Figure 4-2 Coiled Seat Belt Assembly Figure 4-3 Center Seat Belt Fastener