Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 229 / 564

TROUBLESHOOTING AND ELECTRICAL SYSTEM: HONDA POWERED GASOLINE VEHICLES Test Procedures
2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual Page 11b-33
11B
TEST PROCEDURE 23 – 12-VOLT ACCESSORY RECEPTACLE
See General Warning, Section 1, Page 1-1.
NOTE: Keep the battery connected during this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Set the multimeter to 20 VDC.
3. Measure the voltage between the center contact and the outer contact of the accessory receptacle. The
voltage should be approximately 12 VDC.
4. If the voltage is not approximately 12 VDC, check the 10-amp fuse on wire 115 (w115) located on the
electrical component mounting plate. See Test Procedure 2 – Fuse on page 11b-12.
5. If the fuse is good, check the continuity of the wires connected to the accessory receptacle.
TEST PROCEDURE 24 – FUEL LEVEL SENDING UNIT
See General Warning, Section 1, Page 1-1.
ý
WARNING
• To avoid the possibility of fire or explosion, make sure the fuel tank cap is securely in place
while performing this test procedure.
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in NEUTRAL. Chock
the wheels.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-1.
3. Disconnect the orange wire from the center post of the fuel level sending unit.
4. With a multimeter set to 2k ohms, place the red (+) probe on the center post of the sending unit. Place
the black (–) probe on the ground connection of the sending unit (Figure 11b-27, Page 11b-33) .
Figure 11b-27 Fuel Level Sending Unit Test