Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 458 / 564

DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND CLUTCHES Clutches
Page 13c-28 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
13C
If the clutches are not operating properly, perform the following:
1. Check the throttle settings. See Engine RPM Adjustment on page 13c-20.
2. Inspect both clutches for dirt and debris buildup on component parts. Clean the exterior surfaces of both
clutches with water to remove any dust or dirt, then drive the vehicle and check for proper operation. See
Drive Clutch on page 13c-29. See also Driven Clutch on page 13c-33.
3. Check the clean clutches for wear.
4. If cleaning both clutches does not solve the problem, disassemble and thoroughly clean all parts in the
drive clutch. See Drive Clutch Cleaning and Inspection on page 13c-29.
5. Check the drive clutch rollers and weights for wear.
DRIVE BELT
See General Warning, Section 1, Page 1-1.
The drive belt should be inspected periodically for wear and glazing. If it is excessively worn, frayed, or
glazed, replace the belt.
Drive Belt Removal
1. Turn the key switch OFF and remove the key. Set the park brake. Place the Forward/Reverse handle in
NEUTRAL.
2. Disconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
3. Remove the clutch outer cover. See Clutch Outer Cover Removal on page 13c-35.
4. Grasp the belt midway between the drive and driven clutches and squeeze the belt together as tightly as
possible.
5. Guide the belt over the driven clutch and roll the belt off the driven clutch by rotating the clutch clockwise
(Figure 13c-30, Page 13c-28) . See following CAUTION.
ý
CAUTION
• Make sure your fingers are not underneath the belt when rolling the belt off the driven clutch.
Figure 13c-30 Drive Belt Removal