Club Car IntelliTach XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 42 / 564

BODY AND TRIM Front Body Components
Page 4-4 2007 Carryall 295/295 SE & XRT 1550/1550 SE Gasoline, Diesel and IntelliTach M & S Manual
4
7. Secure the outside lower ends of the instrument panel using the two hex bolts (these two bolts also help
secure the top portion of the front fenders).
8. Secure the outside ends and center of the instrument panel with the three Torx
®
screws. (Two screws are
used in the holes behind the cup holders and one screw is used in the hole located inside the glovebox,
closer to the center of the instrument panel.)
9. Install the knob for the Forward/Reverse shift handle by screwing the knob onto the shaft clockwise.
10. Install the steering wheel. See Steering Wheel Installation, Section 7, Page 7-2.
11. Reconnect the battery cables as instructed. See WARNING “To avoid unintentionally starting...” in
General Warning, Section 1, Page 1-2.
12. Unchock wheels.
FRONT FASCIA REMOVAL
1. Remove both side cowl panels (fenders). See Side Cowl Panel (Fender) Removal on page 4-5.
2. Remove the four Torx
®
screws and the three hex head screws that secure the front fascia to the frame.
3. Disconnect the lighting wire harness from each light at connectors.
4. Separate the front fascia from front fenders and remove from vehicle.
FRONT FASCIA INSTALLATION
1. Position the fascia on the vehicle taking care to fit it to the front fenders securely.
2. Connect the lighting wire harness to each light at connectors.
3. Secure the front fascia to the frame using four Torx
®
screws and the three hex head screws.
4. Reinstall both side cowl panels (fenders). See Side Cowl Panel (Fender) Installation on page 4-5.
HOOD REMOVAL
1. Unlatch, raise and securely prop open hood.
2. Remove the four Torx
®
screws that secure the hood to the hood hinge.
3. Separate the hood and the hood hinge and remove hood from vehicle.
4. Retain hardware.
HOOD INSTALLATION
1. Position the hood on the hood hinge.
2. Secure the hood to the hood hinge using the four Torx
®
screws.
3. Lower hood and latch securely.
CENTER COWL PANEL REMOVAL
1. Remove hood. See Hood Removal on page 4-4.
2. The center cowl panel is held in place by four exposed Tuflok plastic locking fasteners and four metal
body trim clips that are hidden from view on the top, underside of the panel. Carefully remove the four
Tuflok plastic locking screws by using a size P2 Phillips head screwdriver. The outer portion of the Tuflok
fastener may be left in the panel at this time.