System Care and Maintenance
LOGIQ 500 Basic Users Manual
2276612–100 Rev. 0
16–14
Cleaning the system (cont’d)
Monitor (cont’d)
Use a soft, folded cloth and a glass cleaner solution. Apply the
glass cleaner to the cloth. Gently wipe the monitor face and
filter.
Do NOT use a glass cleaner that has a hydrocarbon base (such
as Benzene, Methyl Alcohol or Methyl Ethyl Ketone) on
monitors with the filter (anti-glare shield). Prolonged use of
such cleaners will damage the filter (anti-glare shield). Hard
rubbing will also damage the filter.
NOTE: When cleaning the monitor, make sure not to scratch
the monitor.
After cleaning the monitor face and filter, re-install the filter on
the monitor by reversing the removal procedure in Figure 16–1.
Insert the filter clamps and slide them inwards securely.
NOTE: Make sure that the filter is securely fixed by the filter
clamps. These are important to prevent a hazard from the filter
falling. A “click” sound will be heard when the filter clamp is
secured by the lock mechanism.
Operator Controls
To clean the operator control panel:
1.
Moisten a soft, non-abrasive folded cloth with a mild,
general purpose, non-abrasive soap and water solution.
2.
Wipe down operator control panel.
3.
Use a cotton swab to clean around keys or controls.
Use a toothpick to remove solids from between keys
and controls.
NOTE: When cleaning the operator control panel, make sure
not to spill or spray any liquid on the controls, into the system
cabinet, or in the probe connection receptacle.
CAUTION
Summary of Contents for 500
Page 1: ... ...