Introduction
LOGIQ 500 Basic Users Manual
2276612–100 Rev. 0
7–4
Cursors
During the measurement process, the fixed and active cursors
can either be an “X” or “+” symbol. The
“Active Measurement
Cursor”
preset, located on System Parameters page 3, allows
for the choice of the Measurement cursor.
Once the measurement sequence is complete, the cursor
symbol changes to one of the eight shown below.
Figure 7–2. Measurement Completed Cursors
General Mode Measurements Method
When performing measurements, it is possible to choose the
display of and location of the caliper for subsequent
measurements while in B, M or Doppler modes. These presets
(
“B Auto Caliper Control”
,
“M Auto Caliper Control”
and
“D Auto
Caliper Control”
) are located on Preset Program page 4.
Summary of Contents for 500
Page 1: ... ...