Preset Program
LOGIQ 500 Basic Users Manual
2276612–100 Rev. 0
14–82
To program a user table (cont’d)
Type in any desired notes (maximum 30 characters). Press
Return.
Type in the minimum or beginning data value for the table
(maximum 4 digits). Press Return.
Type in the interval value between each table data point
(maximum 4 digits). Press Return.
The selection “Table-Edit” should now be highlighted. Press
Set.
NOTE: The Return key or Trackball can be used to cycle
through the menu selections. To make a choice, press Set.
User Table on EFW
The measurement made by the User Table can be used for the
calculation of EFW. Move the cursor to the right of “Title of” in
the User Table Programming Menu. The available
measurement name for calculation of the EFW is displayed
after the Ellipse rocker switch is pressed.
The OB Report Format preset, located on SetUp/System
Parameters page 2, determines which measurements are
displayed.
Summary of Contents for 500
Page 1: ... ...