Annotating an Image
LOGIQ 500 Basic Users Manual
2276612–100 Rev. 0
6–17
Introduction (cont’d)
Annotations are input in type-over, not insert, mode. Be careful
not to write over text when editing.
NOTE: The comment function will work with any report page.
When the cursor is in a field designated for comments, the
comment key will illuminate and the annotation library will
appear in the Soft Menu. All comment, edit and annotation
functions are then available.
All annotations are permanently retained with the image.
However, annotations are erased at power down or when Clear
or New Patient are pressed.
In addition, the display’s home position can be changed
(preferred annotation area) for each display so that all
subsequent annotations begin in the same spot.
Cursor Home: Established in Set Up/Preset Program page 1,
the cursor returns to the upper left part of the screen or the user
specified position.
A new cursor home position is established by placing the cursor
in the desired position and pressing Ctrl and M. The new
cursor position is placed in the Preset Program values.
To end the Comment/Library annotation function, press Clear.
Comments will be erased.
“Comment Clear Key Function” is a parameter found in the Set
Up/Preset Program page 1. This parameter can be set to erase
all comments on the screen or just the comment line the cursor
is on. With the line selection, the second time Clear is pressed,
all comments will be erased.
“Measurement Clear Operation” is a parameter found in the Set
Up/Preset Program page 3. This parameter can be set to have
only measurements erased with the Clear key or
measurements and comments.
Summary of Contents for 500
Page 1: ... ...