![background image](http://html1.mh-extra.com/html/ducati/monster-s4-fogarty-2002/monster-s4-fogarty-2002_workshop-manual_2537693258.webp)
258
Impianto elettrico / Electrical System
Procedura di sblocco immobilizer
tramite manopola acceleratore
1) Portare la chiave su
ON
e ruotare
completamente la manopola
acceleratore e tenerla ruotata.
La spia
EOBD
si spegne dopo un
tempo prestabilito di 8 secondi.
Note
La spia giallo ambra EOBD (A)
indica il blocco motore quando è
acceso.
Si spegne dopo alcuni secondi
(normalmente 1,8 - 2 sec.).
2) Allo spegnimento della spia
EOBD
rilasciare la manopola.
3) La spia
EOBD
si riaccenderà
pulsando con una frequenza
prestabilita di 0.8 Hz. Quando avrà
emesso il numero di impulsi pari
alla prima cifra del codice,ruotare e
tenere ruotata la manopola
acceleratore.
Viene così riconosciuta l’immisione
di una cifra e la spia
EOBD
si
accende e rimane in questo stato per
un tempo prestabilito di 4 secondi.
Nel caso non si compia nessuna
operazione con la manopola
acceleratore la spia
EOBD
pulserà
per 20 volte, poi si accenderà in
modo fisso e la procedura dovrà
essere ripetuta dal punto (1)
riportando la chiave su
OFF.
4) Allo spegnimento della spia
EOBD
rilasciare la manopola.
5) Ripetere le operazioni ai punti (3 e
4) fino all’introduzione dell’ultima
cifra.
6) Al rilascio della manopola
acceleratore, in caso di codice
correttamente introdotto, la spia
EOBD
si accende in modo
lampeggiante con frequenza di1.6
Hz per indicare l’avvenuto
sblocco.La spia ritorna in condizioni
normali (spenta) dopo 4 secondi. Se
il codice
NON
è stato introdotto
correttamente la spia
EOBD
rimane
accesa ed è possibile ripetere le
operazioni riportando la chiave su
OFF
e ripartire dal punto (1) per un
numero illimitato di volte.
Note
Nel caso la manopola venga
rilasciata prima del tempo
prestabilito, la spia si riaccende ed è
necessario riportare la chiave su
OFF
e ripetere la sequenza dal punto (1).
Funzionamento
Ogni volta che si ruota la chiave del
commutatore da
ON
a
OFF
, il sistema
di protezione attiva il blocco motore.
All’avviamento del motore, ruotando
la chiave da
OFF
a
ON
:
1) se il codice viene riconosciuto, la
spia
CODE
, posta sul quadro
strumenti, emette un breve
lampeggio; il sistema di protezione
A
Immobilizer override through the
throttle twistgrip
1) Turn the key to
ON
, rotate the
throttle twistgrip fully and hold it in
this position.
The
EOBD
light will go out after 8
seconds.
Note
The amber
EOBD
light (A)
comes on to indicate engine block.
It goes out after a few seconds
(normally 1.8 - 2 sec.)
2) Release the throttle when the
EOBD
goes out.
3) The
EOBD
light comes on again
and flashes at a preset frequency of
0.8 Hz. When it has flashed as many
times as the first digit in the code,
rotate the throttle twistgrip and hold
it in this position.
The entry of a code digit is
recognized and the
EOBD
light
comes on and stays on for 4
seconds. If the throttle twistgrip is
left closed, the
EOBD
light will flash
20 times and then will stay on. This
means you have to turn the key
back to
OFF
and repeat the
procedure starting with step (1).
4) Release the throttle when the
EOBD
light goes out.
5) Repeat steps (3) and (4) until
entering all code digits.
6) When the throttle is released, if
the code was entered correctly, the
EOBD
light flashes at a 1.6 Hz
frequency to indicate that engine
operation is enabled. The light goes
out after 4 seconds. If the code was
NOT
entered correctly, the
EOBD
light stays on. The override
procedure may be repeated as
many times as needed to enter the
code correctly, by setting the key to
OFF
and starting over again from
step (1).
Note
If the throttle is released too
soon, the light comes on again. Set
the key to
OFF
and repeat
procedure from step (1).
Operation
Each time the key is turned from
ON
to
OFF
, the immobilizer system
inhibits engine ignition.
When engine is started and the key
is turned from
OFF
to
ON
, the
following happens:
1) if the control unit recognized the
code, the
CODE
light on the
instrument panel will flash briefly.
This means that the system has
recognized the key code and
enabled engine ignition. When you
press the
START
button, the engine
will start up.
Summary of Contents for monster S4 fogarty 2002
