User Setup
PREFERENCES
319
RIVAGE PM10 Operation Manual
5
CUE OPERATION MODE field
Switches between CUE BAY mode and CH mode (
). In BAY mode, you can select
CUE A, CUE B, or CUE A+B for each bay. In CH mode, you can select CUE A, CUE B, or
CUE A+B for each channel.
• CUE SETTINGS popup button
Press this button to display the window, in which you can configure the Cue for each
channel in CH mode (
).
SURFACE SETTINGS2
1
AUTO CHANNEL SELECT field
Specifies whether the corresponding channel will be selected when you operate the [ON] key
or fader for the channel. This can be turned on/off separately for input channels and output
channels.
2
USE FADER TOUCH
If this ON button is turned on, touching a fader will automatically select the corresponding
channel via the Touch Sense function built into the channel fader.
3
FADER TOUCH SENSITIVITY
Touch sensitivity can be adjusted in five steps. Higher values provide greater touch sensitivity.
4
[FADER BANK] > [SEL] LINK
Specifies whether channel selection will be linked with fader bank selection.
You can set this parameter separately for INPUT (input channels), OUTPUT (output
channels), and CUSTOM (Custom fader bank).
If this ON button is lit, and you select the corresponding fader bank, the channel in that bank
that was selected most recently will be selected, and its [SEL] key will light.
NOTE
Changing the Bay Link setting will clear the position of the selected channel stored in each layer.
5
DCA ROLL OUT
No. OF BAYS TO USE
Enables you to select whether the DCA will be rolled out to one bay or two.
6
Fn KEYS ASSIGNMENT
Enables you to select one of the following functions to be assigned to each [Fn] key.
•
NONE
....................................No function will be assigned.
•
INPUT A/B
..........................Switches between INPUT A and B.
•
ISOLATE
..............................Channel Isolate ON/OFF
•
ALTERNATE CUE
..............If the CUE button is set to CUE A, B will be cued. If the CUE
button is set to CUE B, A will be cued. Nothing will happen if
CUE button is set to A+B.
•
ENCODER PARAM
...........On/Off for parameters related to the channel strip encoders
7
LED ASSISTANCE
PANEL ASSISTANCE
If the PANEL parameter in the BRIGHTNESS field is set to less than 50%, turn on this button
to softly light all LED indicators on the panel.
HIGHLIGHT NOMINAL POINTS
If this ON button is lit, the nominal value indication on the panel will be highlighted by the
LEDs.
1
4
2
7
6
5
3