Monitor
CUE
145
RIVAGE PM10 Operation Manual
3
INPUT/DCA/OUTPUT CUE field
Indicates the settings for input cue, DCA cue, and output cue. Press this field to open the CUE
popup window.
4
Meter popup button
This field indicates the output level of the cue L/R channels.
5
CUE LEVEL knob
Sets the output level of each Cue bus.
6
CLEAR CUE button
Cancels all cue selections simultaneously. If the CUE MODE setting is MIX CUE, all of the
selected channels will be cleared.
7
CUE OUTPUT button
Switches Cue Out on or off.
2.
Press the CUE popup button or the INPUT/DCA/OUTPUT CUE field to open the
CUE popup window.
This popup window includes the following items.
1
CUE SETTINGS popup button
Press this button to access the CUE SETTINGS popup window, in which you can select the cue
destination. You can select the cue destination (CUE A, CUE B, or A+B) for each channel.
NOTE
If CUE OPERATION MODE is set to BAY on the PREFERENCES popup window the cue
destination will be specified for each bay. Therefore, this setting will be invalid (
).
2
CUE MODE buttons
Select one of the following two cue modes:
• MIX CUE
All selected channels will be mixed and auditioned.
• LAST CUE
Only most recently selected channel will be auditioned.
3
SOLO ON button
Switches the Solo function on or off.
4
SOLO SAFE popup button
Press this button to access the SOLO SAFE popup window, in which you can exclude a channel
from the mute target in Solo mode (
).
5
INPUT CUE field
This field enables you to make settings related to the input channel cue.
• Cue point select button
Sets the cue point to PRE FILTER (immediately before the filter), PRE FADER (immediately
before the fader), AFL (immediately after the fader), or POST PAN (immediately after
PAN).
NOTE
Be aware that if you select POST PAN, you will be unable to monitor signals sent to the MONO
bus from an input channel that is set to LCR mode.
• INPUT FOLLOW PAN button
If this button is on, the TO STEREO PAN setting will be applied to the pan setting of the
signal sent from input channels to the CUE bus.
• PFL TRIM knob
Specifies the monitor levels when PFL is selected. Use the screen encoder to adjust the value.
4
1
3
2
$
$
&
9
)
!
5
6
7
8
^
&
^
#
#
%
@
9
)
!
@