Siemens SIMATIC ET 200AL, System Manual

Page: 929 / 2255

Digital I/O module F-DI 4+F-DQ 2x24VDC/2A, 4xM12 (6ES7146-5FF00-0BA0)
Equipment Manual, V1.0, 05/2021, A5E51082342-AA
23
Parameters/address space
4
All connected fail-safe I/O must have their operating properties configured by the
STEP 7 Safety configuration software. You have the responsibility to ensure that no
unconfigured modules are connected in a fail-safe automation system.
F-Parameters
You must assign the PROFIsafe addresses (F-destination address together with F-source
address) to the F-module before you put it into operation as follows:
•
You define the F-source address using the "Central F-source addresses" parameter in the F-
CPU.
• An F-destination address unique throughout the project's hardware configuration is
automatically assigned for each F-module. You can manually change the F-destination
addresses assigned in the hardware configuration.
You can find further information on F-parameters such as the F-monitoring time, the
PROFIsafe address assignment (F-source address, F-destination address), F-parameter
signature (with or without addresses) and the F-I/O DB in the SIMATIC, Industrial Software,
SIMATIC Safety - Configuring and Programming, Programming and Operating Manual on the
Internet ( https://support.industry.siemens.com/cs/ww/en/view/54110126 ) .
4.1 Configuring module I/O properties
To configure fail-safe module I/O properties, follow these steps:
1.
Select the image of a fail-safe I/O device (on the Device view or Device overview) and view
the module's "Properties" tab.
2. On the "Properties" view, select the "General" tab.
3. Select a property category in the left-side property tree and then set values in the right-side
property fields.
4. A successful compile and download of your hardware configuration to one of the following
CPUs automatically puts your new configuration settings in the I/O modules:
– ET 200pro F
– ET 200SP F
– S7-1200 F
– S7-1500 F
– Prior generation S7-300 F and S7-400 F