Siemens SIMATIC ET 200AL, System Manual

Page: 595 / 2255

PROFIenergy
7.2 Behavior of the digital output module
Digital output module DQ 8x24VDC/2A 8xM12 (6ES7142-5AF00-0BA0)
26
Equipment Manual, 08/2021, A5E36683723-AB
7.2 Behavior of the digital output module
Display
The channel status LEDs are directly affected by the signal level at the socket.
Response to error detection
All channels that are in pause mode on "PE_MODE_PROCEED" report their diagnostic status as
in productive mode.
The following applies for all channels which switch to a different pause mode:
•
During the "pause", error detection of "Short circuit" is not possible:
– Alarms for errors already pending before the "pause" are retained.
– After the "pause" is over, the error status is updated and incoming/outgoing errors are
reported correspondingly.
Mode parameter
The following table shows the "Mode" parameter.
Table 7- 1 Mode parameter
Element Code Explanation
Mode 0
D
: PE_MODE_PROCEED Proceed at "pause"
•
Value status "GOOD"
1
D
: PE_MODE_SHUTDOWN Switch off at "pause"
•
Pause substitute value: 0
B
• Value status "BAD"
3
D
: PE_MODE_LAST_VALUE Last value at "pause"
•
Pause substitute value: Last output value is main-
tained
• Value status "BAD"
4
D
: PE_MODE_SUBST_VALUE Substitute value at "pause"
•
Pause substitute value: Configured pause substi-
tute value is output
• Value status "BAD"