Novexx Solutions ALX 92x, Service Manual

Page: 307 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
109
Remote operator panel
Prerequisites
•
Device with electronics Gen. 3 (CPU board
A6621)
•
Drilling for connector mounting is available
•
Remote operator panel upgrade kit (article
number A8719)
The upgrade kit contains:
– Remote operator panel (article number
A8293)
– Internal cable (article number A8380)
Assembly of internal cable
(ALX 92x)
Tools
•
Cross-head screwdriver, small size
•
Hex socket wrench, size 4
Assembly
1. Remove the rear hood, see chapter Rear
hood (ALX) on page 12.
2. a) Drilling hole [242A] for connector moun-
ting is available: remove the cap.
b) Drilling hole for connector mounting is
not available: drill the holes according to
[241] and [242].
3. Hold the connector from inside against the
side panel

The connector key [242B] must face the
built-in boards.
4. Push two screws (M2x16) from outside
through the side panel and the connector
holes. Mount lock washers and nuts on
each of the screws; tighten the nuts. Lock
each nut with a second nut [243, arrows].

Continue with step 5 on page 111 .
[240] Remote operator panel.
[241] Sizes and positions of drilling holes for the connector
mounting.
[242] Connector (A) for the remote operator panel at an ALX 92x
side panel (RH). Connector key position (B).
[243] Connector locked with a second nut (arrows) on each side.
19 ±0,1
Ø12,70
-0,1
2x 2,50 Ø
A
B