Novexx Solutions ALX 92x, Service Manual

Page: 652 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
130
Material signal
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Concerns the output signal WARNING at the USI, which indicates the close
shortness of ribbon or material.
On High, if the diameter of the material roll falls below a certain value. The limit
diameter is set by positioning the outer diameter (OD) sensor.

Requirement: "OD sensor material" is installed.
Off
No material end warning.
Mat. signal stop
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Defines the reaction of the printer on a material low signal coming from the
OD-sensor.

See
DP INTERFACE > Material signal
Off
(Default) The output signal WARNING at the USI is activated (precondition:
DP INTERFACE > Material signal
is set to „enabled“). The printing will be continued.
On After a material low warning occured, the printer finishes printing the current
label and stops afterwards. The display shows:
After acknowledging the message, the printing can be continued.
Feed input
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Concerns the output signal FEED at the USI.
Standard (Default setting) Feed of blank labels as long as signal is "low".
Precondition: Off-line mode or printing stopped in on-line mode.
JP5
A signal different from the standard FEED can be used. Precondition: an ap-
propriate firmware change (NISTAN).
Print Status: 5123
USI Material low