Novexx Solutions ALX 92x, Service Manual, Page: 208 / 824

06/16 Rev. 09 SERVICE MANUAL Service Mechanics
DPM – PEM – ALX 92x
10
2. Open rear hood [7].

To do this carefully pull the entire rear
hood back as shown and at the same time
open up the right-hand lateral part.
3. Remove the power supply

Refer to chapter Exchanging the HME
power supply on page 97.
4. Remove the USI board.

Refer to chapter USI board (DPM/PEM) on
page 89.
5. Remove the CPU board.

Refer to chapter CPU board (DPM/PEM)
on page 91
6. Undo the fastening screws from the nine
clips [8A] on the rear hood frame [8B].
Take off the rear hood.

Lift the frame carefully over the "inn-
ards" of the DPM.
Assembly
To assemble the device, follow the steps in
the reverse order.
[7] Open the rear hood. At the same time open up the right si-
de.
[8] Clips (A) on the frame (B) of the DPM rear hood.
A
B