Novexx Solutions ALX 92x, Service Manual

Page: 637 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
115
LA-SO
L abel A pplicator S wing O n, applies the label with a rotation movement.

For details refer to the User Manual LA-SO

LA-TO Timed L abel A pplicator T amp O n, time controlled
LA-TO Sensor LA-TO, sensor controlled
LA-TO BO Timed
L abel A pplicator T amp O n with B low O n function, time controlled
LA-TO BO Sensor
L abel A pplicator T amp O n with B low O n function, sensor controlled

For details about LA-TO and LA-TO BO refer to the User Manual LA-TO

Application mode
ALX 92x DPM

Only with an AI installed.
Defines, if the application process starts with applying („After start signal“) or
with printing the label. Precondition: A printjob is loaded and the printer is in
online mode.
After print The start signal triggers the immediate printing, dispensing and applying of a
label.
After start sig. The start signal triggers the application of an already printed and dispensed
label. After applying the label, the next one is immediately printed and dis-
pensed.

A flow chart illustrating the application process can be found in the User
Manual LTP/LTPV
 , topic section "Installation / Setup", paragraph „Product
description“ > "Function diagram LTSI / LTP / LTPV".
Start print mode
ALX 92x DPM

Only with an AI installed.
Selecting a print mode. Depending on the selected mode, the start signal will
be interpreted differently by the AI.
Requirements:
•
SYSTEM PARAMETER
> External signal = „Singlestart“
•
A printjob was transferred (DATA READY)
•
Printer is switched „Online“
•
No error messages

Start Print Mode replaces the Parameter
SYSTEM PARAMETER
> Signal edge ,
which can be found in older firmware versions.

Further information about using a start signal: Read the user manual, topic
section „Advanced Applications“, chapter Printing with start signal

.

64-xx: This parameter has priority over
SYSTEM PARAMETER > Signal edge
,
which is relevant for setting the triggering of the single start connector.
Pulse fall/ris The printing of a label is triggered by a low-high-change as well as by a high-
low change of the start signal. The printing occurs only after the
set delay time.