Novexx Solutions ALX 92x, Service Manual

Page: 763 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
74
9009 Temporary MAC
Temporary MAC address.
Status This error message is displayed, if the MAC address has the value
00.0a.44.00.00.00 . This MAC address is used only during production.
Measure

Acknowledge the status message by pressing the Online button. The
printer will be starting and the network can be used.
 Contact the technical support for a new programming of the board´s MAC
address.

If a new programming is not possible, exchange the CPU board.
9011 Bootloader ext.
Bootloader external device.
Status At least one external device (e.g. AI, BLDC output stage) has no valid (e.g.
an incomplete) application program loaded. This is the reason, why the
device remains in the bootloading status and signalizes this status
message.The error can only occur, until now (05/04), if an AI is applied.
Measure  Load a valid application program.
9013 Head voltage
Status Faulty 5 V print head supply voltage. Possible causes are:
•
Only AP 5.4 : Printhead was connected to the wrong connector on the CPU
board.
•
Short circuit, possibly is the printhead defective.
Measure  Only AP 5.4 : Check if the printhead is connected to the correct connector
on the CPU board. Change the connector, if necessary.
 Replace the printhead
9014 Motor voltage
Status Faulty 45 V motor supply voltage. A possible cause is a short circuit, that is
the printhead is defective.
Measure  Replace the printhead
9015 Network init.
Status Error during the network initialization.
Measure

Contact your network administrator.
9016 DHCP Failed
Status DHCP failed. This may happen, if parameter INTERF. PARAM. >
ETHERNET PARAM. > IP Adressassign
is set to DHCP , but no IP-address can be
drawn.
Measure

Contact your network administrator.