Novexx Solutions ALX 92x, Service Manual

Page: 736 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
47
5072 Material end unw
Status Occurs during operation with activated internal OD control. The message
appears, if no rotation of the mate-rial roll has been registered during at
least 600 mm of material feeding.
Measure

Check the material feeding; if necessary, replenish the material roll.
5100 No H8 response
Status Communication fault with H8 processor (occurs only at devices with Gen. 2
electronics).
Measure

Acknowledge by pressing the Online button.

Switch device off and on again.
If the message continues to appear:
 Contact service technician.
Instructions for service technicians:
The error can occur in connection with the exchange of the CPU board of
an ALX 92x machine.
 Acknowledge error, set all sensors, restart.
 If the error message still appears: Reload firmware and/or carry out a
forced bootloader start with "Clear params".

If the error continues to appear: send CPU board with a fault description to
the manufacturer.
5100 Printengine lock
Status Printengine error (occurs only at devices with Gen. 3 electronics).
Measure  Acknowledge by pressing the Online button.
 Switch device off and on again.
If the message continues to appear:

Contact service technician.
5101 Headadjust error
Status Error during the running of the "Head Alignment" service function.
Measure  Acknowledge by pressing the Online button.

Contact service technician.
5102 Dot Defective
Status Defective dot detected during the running of the "Head dot test" service
function.
Measure  Acknowledge by pressing the Online button.