05/16 Rev. 03
USER- / SERVICE MANUAL
Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6
AP 4.4 – AP 5.4
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
120
I/O BOARD
This menu appears only if the optional I/O Board is mounted.
Start print mode
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
AP 5.4
AP 5.6
Only with an I/O board mounted.
Selecting a print mode. Depending on the selected mode, the input signal
START_PRINT will be interpreted differently by the I/O Board signal inter-
face. The parameter is also used for the device connected to the foot switch
jack.
•
Make sure to select
SYSTEM PARAMETER > External Signal
= „Single Start“.
•
Note: The parameter
Start Print Mode
replaces the parameter
Signal Edge
in the
SYSTEM PARAMETER
menu.
•
Preconditions: Print job is available (DATA READY), printer is in “Online”
mode, no error messages.
Pulse falling
(Default setting) The printing of a label is triggered by a high-to-low change
of the signal at the input START PRINT. The printing occurs only after the set
delay time.
Pulse rising
The printing of a label is triggered by a low-high change of the signal at the
input START PRINT. The printing occurs only after the set delay time.
Pulse fall/ris
The printing of a label is triggered by a low-high-change as well as by a high-
low change of the signal at the input START PRINT. The printing occurs only
after the
set delay time.
Level low active
Labels will be printed as long as the signal at input START PRINT is held low.
Level high activ
Labels will be printed as long as the signal at input START PRINT is held
high.
Reprint Signal
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
AP 5.4
AP 5.6
Only with an I/O board mounted.
Off
The input signal is disabled
On
The last printed label will be reprinted on the falling edge of the REPRINT
signal.
Preconditions:
•
The label to be reprinted, should be printed and dispensed.
•
Printer is in online mode.
If a REPRINT is triggered while the printer is in “I/O-Board Pause” mode,
the
reprint will proceed as soon as the printer is switched back in online mode.
Precondition: in level mode START PRINT must be inactive.
Summary of Contents for ALX 92x
