Novexx Solutions ALX 92x, Service Manual

Page: 112 / 824

04/16 Rev. 06 USER MANUAL Advanced Applications
AP 4.4 – AP 5.4 – AP 5.6 – AP 7.t – 64-xx – DPM – PEM – ALX 92x
37
Setup
1. Place the printer on the OLV mounting plate as illustrated.

Operating the OLV at a DPM / PEM / ALX 92x requires a support stand match-
ing the respective installation situation
2. Connect the OLV to the serial interface of the printer.

After the printer has been switched on, initialization commands are sent to the
OLV. Therefore, the OLV has first to be switched on. These initialization com-
mands switch on the laser beam (among other things).

The sending of the initialization commands can be repeated at any time by
pressing the Feed and Esc buttons (at the printer) simultaneously. This may be
necessary, if the OLV was switched off.
3. Switch on the OLV.
4. Switch on the printer.
5. Set the printer parameter
INTERF. PARAM. > OPTIONS > OLV option to „Serial Com1“
or „Serial Com2“, depending on the port on which the OLV is connected.

(Firmware 3.30: Set the printer parameter INTERF. PARAM. > COM2 PORT >
Function Option to „Barcode OLV“.)
The data transfer parameters of the interface are automatically set to the default
values required by the SV100 (115 200 baud, 8 data bits, no parity, 2 stop bits,
hardware handshake).
6. Position the OLV so, that the distance between laser beam (on the label) and print-
head is as short as possible.

For detailed information on setting the OLV please refer to the SV100 manual.
7. Set the parameters in the
OLV PARAMETERS
menu (at the printer).
Information about the parameters can be found in topic section Info-Printouts and
Parameters

.
[21] 64-05 with OLV mounted (front view).