Novexx Solutions ALX 92x, Service Manual

Page: 670 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
148
This is relevant for label stock with very long punches. To avoid those punch-
es being recognized as material end by mistake, can here the distance be
set, after which the gap over the light sensor is interpreted as material end.

By choosing a very high material end tolerance, you loose the protection
of the print roller against being printed on!
xxx mm
Setting range: 20-300 mm; Default setting: 35 mm
Feedadjust label
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Prints a scale, which enables to calculate the feed adjust value (see next
parameter).
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter
Adjusting the imprint position  .
Feed adjust
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6
Corrects the material feed length. Such a correction can be necessary when
printing on very long labels, to compensate slippage-related feeding inaccu-
racy.
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter
Adjusting the imprint position  .
x.x% [ribbon] Setting for thermal transfer printing
Setting range: -10.0 to +10.0; Step width: 0.1%; Default setting: 0%

Only appears if thermal transfer printing was selected (see
SYSTEM
PARAMETER > Ribbon autoecon. )
x.x% [direct] Setting for thermal direct printing
Setting range: -10.0 to +10.0; Step width: 0.1%; Default setting: 0%

Only appears if thermal direct printing was selected (see
SYSTEM
PARAMETER > Ribbon autoecon.
)
Punch y calibr.
64-xx ALX 92x DPM PEM ALX 73x (PMA) AP 4.4 AP 5.4 AP 5.6

Only in production mode
Compensating the variation of distance between punch sensor and thermal
bar of the printhead.
x.x mm
Setting range: -3.0 to 3.0; Default setting: 0.0; Unit interval: 0.1
Foil feed adjust
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only in production mode.