12/14 Rev. 05
SERVICE MANUAL
Service Electronics
64-xx Gen. 2 – DPM Gen. 2 – ALX 92x Gen. 2
16
6
REPRINT\
In
The last printed label is being reprinted as long as REPRINT\ is low.
Minimum reprint quantity: 1 label.
Preconditions:
•
The label which is ought to be reprinted, must be ready printed and dispen-
sed.
•
Printer is in online mode.
If a REPRINT\ is triggered while the printer is in USI-pause mode, the reprint
will be proceeded as soon as the printer is switched back in online mode.
Precondition: START PRINT\ inactive (high).
7
24V_EXT
Voltage
supply
Voltage supply for external sensors
8
GND_EXT
Ground
Ground contact
9
WARNING
Out
•
Bad-Tag warning:
The signal is activated (high), if
a)
DP INTERFACE > USI profile
= „Bad Tag“
b) Reading/writing a RFID tag failed.
Notice: The required USI firmware version for this function is 9.
•
Ribbon low warning:
The signal is activated (high), if
a)
DP INTERFACE > Ribbon signal
= „
On“
and
b) The ribbon stock is below the threshold value, which is set in parameter
SYSTEM PARAMETER > Foil end warning
.
After changing the ribbon roll, the signal will be inactivated after a short time.
•
The signal is activated (high), if
a)
DP INTERFACE > Material signal
= „
On“
and
b) The label material stock is below the threshold, which is set by positioning
the light barrier
After changing the material roll, the signal will be inactivated.
The WARNING output is only then inactivated (low), if ribbon and material both
are available in a sufficient amount. If one of both rolls falls below the threshold
value, the output switches activ (high).
In practice, the more or less eccentric running material roll will trigger the ma-
terial warning repeatedly, until the roll diameter falls below a certain tolerance
zone.
This signal is only a warning, what means that the printing goes on.
10
ERROR\
Out
This output is activated (low) during every status which keeps the printer from
printing:
USI-pause mode, stopped mode, offline mode, hood open, material end, no
punch recognized, pressure roller open, ribbon end and other failures which
avoid printing.
During the initialization of the printer, the output is inactive (high)!
11
PRINT_END\
Out
The manner in which this output is switched depends on the setting of parame-
ter
DP INTERFACE > End print mode
.
Difference to older versions of printer firmware (below 2.46): The output is now
also activated as long as labels are fed.
Limitation: This functionality is not available in Batch mode!
Pin Signal
Signal
type
Function
Tab. 4: (Continued) Signal designations and functions of the USI interface.
Summary of Contents for ALX 92x
