Novexx Solutions ALX 92x, Service Manual

Page: 724 / 824

04/16 Rev. 11 USER + SERVICE MANUAL /Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
35
4100-4106 Message, which can only occur with OLV-Option
4100 No OLV data
Status The OLV found out, that the bar code type and/or the bar code data, which
was just printed and read, doesn´t match the bar code specified in the print
job. The error may have one of the following causes:
•
OLV is not connected/switched on
•
The bar code has not been printed
•
The bar code has been printed poorly, so that the OLV can not detect it.
Measure  Check, if the OLV is connected correctly
 Check the printout quality. If the printout is poor, change the print
parameters and/or use a different material/ribbon-combination.

Make a dot check. May be, that a dot is defective, which was ought to print
an important line of the bar code.
 If the bar code has not been printed at all: check the print job.
4101 OLV limit exceed
Status The read bar code exceeds a user-specified limit. The limits, e.g. contrast
or readability, can be set via the parameter menue or via Easy Plug
command.
Measure  Check the printout quality.
 Change the limit.
 Eventually modify the print parameters or the material/ribbon combination.
4103 OLV barcode type
Status The OLV found out, that the bar code type, which was just printed and
read, doesn´t match the bar code specified in the print job.
Measure  Check the printout.
4104 OLV Timeout
Status General software error
Measure

Please read the notes in section General software errors  .