Novexx Solutions ALX 92x, Service Manual

Page: 654 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
132
Apply mode
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.

Only, if
DP INTERFACE > Interface type
= „USI Applicator“.
Defines, if the application process starts with applying („After start signal“) or
with printing („After print“). Requirements: Printjob transferred, printer is
switched „Online“.
After print
The start signal triggers the immediate printing, dispensing and applying of a
label. Precondition: A printjob is loaded and the printer is in online mode.
After start sig. The start signal triggers the application of an already printed and dispensed
label. After applying the label, the next one is immediately printed and dis-
pensed. Precondition: A printjob is loaded and the printer is in online mode.

For detailed information about the applicate mode refer to the Technical
Manual LTSI, topic section "Specifications", paragraph "Function diagram
LTSI / LTP / LTPV".
USI profile
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board (minimum required USI firmware version: 9).
Standard Standard setting without forwarding the BTS (Bad Tag Signal).
Bad Tag Forwards the BTS to the „Warning“ output of the USI (pin 9). The BTS is gen-
erated, if a read/write operation on a RFID-Tag failed.
Warning signal
64-xx DPM PEM ALX 92x

Only with USI board (minimum required USI firmware version: 9).
Level low active
The warning signal will be activated with low level.
Level high activ (Default setting) The warning signal will be activated with high level.